压力容器2011，Vol.28Issue(1)：33-39,7.DOI:10.3969/j.issn.1001-4837.2011.01.007
压力容器分析设计的塑性分析方法
Plastic Analysis Methods for Design by Analysis of Pressure Vessels
陆明万 1寿比南 2杨国义2
作者信息
- 1. 清华大学工程力学系,北京100084
- 2. 中国特种设备检测研究院,北京100013
- 折叠
摘要
Abstract
Plastic analysis methods for design by analysis of pressure vessels are introduced and reviewed in this paper. The ASME Ⅷ - 2 2007 is taken as the mainline of the introduction, and the European standard EN 13445 2002 is also involved. The limit -load analysis method and elastic -plastic stress a-nalysis method of ASME Code, as well as the direct route of European standard are included in this introduction.关键词
极限载荷分析/弹塑性分析/直接方法/压力容器分析设计分类
通用工业技术引用本文复制引用
陆明万,寿比南,杨国义..压力容器分析设计的塑性分析方法[J].压力容器,2011,28(1):33-39,7.
