铸造技术2011，Vol.32Issue(5)：676-679,4.
基于ProCAST软件叶轮离心铸造计算机模拟前处理
Preprocessing of Centrifugal Cast Impeller Based On ProCAST
高颖 1王自东 1赵永龙 1游龙 1张伟 1陈瑞峰1
作者信息
- 1. 北京科技大学材料科学与工程学院,北京,100083
- 折叠
摘要
Abstract
Based on ProCAST software, the pre-processing on the simulation of filling and solidification of typical bronze impeller centrifugal casting was carried out.Through the discussion on interface mode between PRO/E and ProCAST and foundry process design for impeller, and settling accurate selection of simulation parameters, therefore, a good foundation to the further follow-up process simulation was laid out.关键词
ProCAST/叶轮/接口方式/网格划分Key words
ProCAST/ Impeller/ Interface mode/ Meshing分类
金属材料引用本文复制引用
高颖,王自东,赵永龙,游龙,张伟,陈瑞峰..基于ProCAST软件叶轮离心铸造计算机模拟前处理[J].铸造技术,2011,32(5):676-679,4.
