RDX激光点火的一维气相模型OA北大核心CSCDCSTPCD
One-Dimensional Gas-Phase Reaction Model of Laser-Induced Ignition of RDX
为了研究含能材料RDX在激光作用下的点火特性,在Liau等人的工作基础上,考虑了物理参数随温度和组分浓度的变化,建立了RDX激光点火的气相模型.利用有限差分方法,计算了激光功率密度为400 W/cm2、环境压力为0.1 MPa时RDX的点火过程.结果表明:约90%的RDX以蒸发的形式进入气相,另外的10%在液相中发生分解;气相中随着反应物的增加和温度的升高,反应逐渐加剧,最终达到点火.计算得到的点火延迟时间为10 ms,与已报道的研究结果基本一致.
Based on the work of Liau et al. ,a one-dimensional gas-phase reaction model of laser-induced ignition of RDX was established by considering the variations of physical parameters with temperature and component concentration. Using this gas-phase reaction model and finite difference method, the ignition characteristics of RDX ignited by laser radiation of 400 W/cm2 power density at 0. 1 MPa and 300 K were investigated. The calculated results showed that about…查看全部>>
田占东;张震宇;卢芳云;谭福利
国防科技大学理学院技术物理研究所,湖南长沙410073国防科技大学理学院技术物理研究所,湖南长沙410073国防科技大学理学院技术物理研究所,湖南长沙410073中国工程物理研究院流体物理研究所,四川绵阳621900
数理科学
激光点火RDX点火延迟时间数值计算
laser-induced ignition RDX ignition delay time numerical simulation
《高压物理学报》 2011 (2)
138-142,5
国家自然科学基金委员会-中国工程物理研究院NSAF联合基金(11076029)
评论