金刚石与磨料磨具工程2011，Vol.31Issue(3)：57-60,4.DOI:10.3969/j.issn.1006-852X.2011.03.015
磨削印刷线路板铣刀时的锯齿现象及其消除
The aliasing phenomenon and its elimination during the grinding of PCB milling cutters
摘要
Abstract
The edge aliasing phenomenon on the cutter used for printed circuit board (PCB) milling often occur during the grinding with diamond wheel. In this paper, the effects of wheel diamond grit size, wheel speed and feed rate on the edge aliasing were studied. The results showed that the quality of cutting edge of milling cutter was improved with the decrease of wheel diamond grit size. The wheel speed and feed rate also had influence on the quality of the cutting edge. The wheel diamond grit size was the most important influencing factor on the cutting edge.关键词
金刚石砂轮/PCB用铣刀/刀刃锯齿现象Key words
diamond wheel/ cutters for PCB milling/ aliasing edge分类
矿业与冶金引用本文复制引用
林高安..磨削印刷线路板铣刀时的锯齿现象及其消除[J].金刚石与磨料磨具工程,2011,31(3):57-60,4.基金项目
国家科技支撑计划(2007BAE05B03) （2007BAE05B03）
