油管外表面气动喷砂两相流场数值模拟OA北大核心CSCDCSTPCD
Numerical Simulation of Two-phase Flow Field on Outside Blasting of Tubing
为了确定油管外表面气动喷砂的工艺参数,采用遵循欧拉-拉格朗日方法的离散相颗粒模型,对不同工况条件下的气固两相流场进行数值模拟。首先采用S-A湍流模型对连续相流场进行数值模拟,得到了气相流场的特性;再采用颗粒轨道模型对固体颗粒相流场进行计算;最后,在仿真计算过的气相流场中加入固体颗粒相,求解颗粒的受力情况,得出颗粒轨迹和速度。结果表明：当喷射距离在100mm、粒子直径在0.5～1.0mm之间时,粒子喷射到油管外壁的速度最大,并且能够覆盖外壁全表面,喷砂效果最佳。
In order to confirm the technologic parameters on the outside blasting of tubing,a numerical simulation of solid-gas two-phase flow was performed under different operating conditions.A discrete particle model following the Eulerian-Lagrangian method was applied to the simulation.The Spalart-Allmaras turbulence model was applied to simulate the continuous phase flow field.The gas flow field characteristics were obtained.The particle-trajectory model was appli…查看全部>>
王金东;吕志利;李新伟;王巍
东北石油大学,大庆163318东北石油大学,大庆163318东北石油大学,大庆163318东北石油大学,大庆163318
机械制造
油管喷砂气固两相流数值模拟
tubingblastingsolid-gas two-phase flownumerical simulation
《中国机械工程》 2011 (15)
1815-1818,4
黑龙江省科技攻关项目（GZ07A502)
评论