中国电机工程学报2012，Vol.32Issue(13)：I0015-I0015,1.
Transient Fault Locating Method Based on Line Voltage and Zero-mode Current in Non-solidly Earthed Network
Transient Fault Locating Method Based on Line Voltage and Zero-mode Current in Non-solidly Earthed Network
ZHANG Linli 1XU Bingyin 2XUE Yongduan 3GAO Houlei1
作者信息
- 1. Shandong University
- 2. Shandong University of Technology
- 3. China University of Petroleum （East China）
- 折叠
摘要
Abstract
Non-solidly earthed systems are widely used for middle voltage distribution network at home and abroad. Fault point location especially the single phase-to-earth fault is very difficult because the fault current is very weak and the fault arc is intermittent. Although several methods have been developed, the problem of fault location has not yet been resolved very well. A new fault location method based on transient component of line voltage and 0-mode current is presented in this paper, which can realize fault section location by the feeder automation （FA） system. Line voltage signal can be obtained conveniently without requiring any additional equipment. This method is based on transient information, not affected by arc suppression coil.关键词
低压配电网络/瞬态故障/定位方法/接地电流/线电压/非直接接地系统/单相接地故障/馈线自动化Key words
fault location/non-solidly earthed distribution network/transient component/line voltage/feeder terminal unit(FTU)分类
信息技术与安全科学引用本文复制引用
ZHANG Linli,XU Bingyin,XUE Yongduan,GAO Houlei..Transient Fault Locating Method Based on Line Voltage and Zero-mode Current in Non-solidly Earthed Network[J].中国电机工程学报,2012,32(13):I0015-I0015,1.
