首页|期刊导航|电焊机|焊接速度对18-8不锈钢堆焊层组织形态的影响

焊接速度对18-8不锈钢堆焊层组织形态的影响OA北大核心CSTPCD

Influence of welding speed on morphology of 18-8 stainless steel cladding layer

中文摘要英文摘要

采用带极电渣焊方法在Q235表面得到了18-8不锈钢堆焊层.研究不同焊接速度对18-8不锈钢堆焊层组织形态的影响.结果表明,带极电渣堆焊层显微组织主要由奥氏体和少量δ铁素体构成,其中δ铁素体有断续状(或称蠕虫状)、骨架状和板条状三种形态,决定于堆焊层的合金成分、焊接热输入及冷却条件等因素.当焊速过小时,堆焊层组织中δ铁素体的形态主要是断续状和骨架状;当焊速过大时,δ铁素体的形态主要是板条状和骨架状;当焊速适中时,可获得热输入小、稀释率低、成形良好…查看全部>>

The cladding of 18-8 stainless steel is prepared on the surface of Q235 by eleclroslag welding.The influence of varied welding speeds on morphology of cladding layer is researched.The results show that.the microstructure of electroslag cladding is mainly austenite and small amounts of 8 -ferrite.Three forms of 8 -ferrite,intermittent ferrite morphology (or worm ferrite morphology), skeleton ferrite morphology and lathy ferrite morphology,is observed.Which fo…查看全部>>

张志玺;包晔峰;杨可;蒋永锋

河海大学机电工程学院,江苏常州213022河海大学机电工程学院,江苏常州213022河海大学机电工程学院,江苏常州213022河海大学机电工程学院,江苏常州213022

矿业与冶金

组织形态焊接速度18-8不锈钢

structuremorphologywelding speed 18-8 stainless steel

《电焊机》 2012 (5)

43-46,4

评论

您当前未登录!去登录点击加载更多...