电力系统自动化2012，Vol.36Issue(14)：83-87,5.
基于补偿特性的并联型有源电力滤波器直流侧电压取值分析
Design of Voltage in DC Link of Parallel-type Active Power Filter Based on Compensation Characteristics
摘要
Abstract
The value of voltage in dc link of parallel-type active power filters （PAPFs） is directly influencing the performance of compensation. An extensive analysis of compensation characteristics in PAPF is carried out. First, respectively in the single- phase system and the three-phase system for load current of a thyristor rectifier with resistive and inductive load, the theoretic minimum of voltage in dc link for harmonic full compensation is obtained through equivalent circuits analysis. Then, when voltage in dc link is smaller than the theoretic minimum and under sinusoidal pulse width modulation control strategy, the quantitative relationship between the total harmonic distortion （THD） of current after compensation and voltage in dc link is also elaborated by using the simulation curves. With these curves, the selection of voltage rated value in dc link for PAPF is quite straight forward. The simulation and experimental results verify the correction of selected volt~ge in dc link.关键词
有源电力滤波器/直流侧电压/谐波特性/补偿特性Key words
active power filter/voltage in dc link/harmonic characteristics/compensation characteristics分类
交通工程引用本文复制引用
赵国鹏,林少伯,韩民晓..基于补偿特性的并联型有源电力滤波器直流侧电压取值分析[J].电力系统自动化,2012,36(14):83-87,5.基金项目
中央高校基本科研业务费专项资金资助项目 （）
新能源电力系统国家重点实验室自主研究课题资助项目~~ （）
