中国钼业2013，Vol.37Issue(4)：46-49,4.
细钼丝聚晶拉丝模孔型参数的探讨
DISCUSSION ON THE POLYCRYSTALLINE WORTLE PASS PARAMETERS OF FINE MOLYBDENUM WIRES
黄立峰 1李世伟 1刘宝庆 1卜春阳2
作者信息
- 1. 金堆城钼业光明(山东)股份有限公司,山东淄博255300
- 2. 金堆城钼业股份有限公司技术中心,陕西西安710077
- 折叠
摘要
Abstract
The pass parameter changing of fine molybdenum wire are detected by CU-10 Inspector in accordance with factory's actual processing,such as compression angle,length of the sizing area,ovality,and etc.Then the best operating scope of pass parameter is determined so that the drawing dies'quality and operating life are improved.关键词
钼丝/拉丝模/压缩角/定径区/椭圆度Key words
molybdenum wire / drawing die / compression angle / sizing area / ovality分类
矿业与冶金引用本文复制引用
黄立峰,李世伟,刘宝庆,卜春阳..细钼丝聚晶拉丝模孔型参数的探讨[J].中国钼业,2013,37(4):46-49,4.
