华西口腔医学杂志Issue(1)：36-39,4.DOI:10.7518/hxkq.2014.01.009
采用锥形束CT测量牙体长度的准确性研究
Investigation of accuracy of premolar length measured by cone beam CT in vivo
摘要
Abstract
Objective To investigate the feasibility and accuracy of length measurement of in vivo teeth by using cone beam CT (CBCT). Methods Before orthodontic extraction, 109 vital premolars from 40 participants were scanned by using CBCT and reconstructed by using InVivoDental software. Buccal-lingual sectional images along the long axis of teeth were then acquired, and the crown, root, and tooth length were measured separately. After careful extraction and fixation, the cor-responding length of the same tooth was measured by using a digital caliper. CBCT measurement accuracy was then verified by using physical measurements as reference. Results CBCT and the physical method did not obtain significantly different measurements of the root, crown, and tooth length of experimental teeth (P=0.790, P=0.621, P=0.657, respectively), and the measurements were found to be consistent. The 95% limits of agreement of root, crown, and tooth length were -1.10 mm to 1.13 mm, -1.00 mm to 0.96 mm, and -1.00 mm to 1.05 mm, respectively. Conclusion The difference between CBCT and the physical method was not significant, and good consistency was shown. CBCT could be applied in noninvasive measure-ment of in vivo teeth.关键词
锥形束CT/牙体/长度测量/多平面重建/精确度Key words
cone beam CT/tooth/length measurement/multi-planar reconstruction/accuracy分类
医药卫生引用本文复制引用
冯驰,李丛华,曾兴琪,王勤花,郑谦,邱叶..采用锥形束CT测量牙体长度的准确性研究[J].华西口腔医学杂志,2014,(1):36-39,4.基金项目
重庆市科学技术委员会基金资助项目(cstc2013jcyjA10010) （cstc2013jcyjA10010）
