华西口腔医学杂志Issue(5)：484-487,4.DOI:10.7518/hxkq.2014.05.014
眶部种植体长度对骨界面应力影响的三维有限元研究
Three-dimensional finite element analysis of the effect of orbital implant lengths on stress distributions in peri-implant ;surfaces
摘要
Abstract
Objective This study aims to observe the effect of orbital implant lengths on stress distribution in peri-implant surfaces. Methods The three-dimensional finite element analysis models of craniofacial and orbital implants with a diameter of 3.75 mm and lengths of 3, 4, 6, and 10 mm were established. A force of 20 N was applied to the models. The stress and displacement distribution under every condition were recorded and analyzed. Results The loading direction along the implant axis and the stress concentration on the implant root were observed. The loading direction was at a 45 degree angle relative to the implant axis, and the stress concentration was located at the implant neck and the first screw thread. The maximum stress of the 3 mm implant was significantly higher than that under the other two loading directions. The maximum displace-ment of the four lengths exhibited no significant change. Given the same implant length, stress, and displacement, the peak of the implant axial direction was lower than that of the 45 degree direction. The loading type was an important factor influencing the stress and displacement of peri-implant bones. Conclusion The implants of more than 4 mm length can be considered for clinical use. The implant of 3 mm length should be implanted in a region with thicker cortical bone.关键词
眶部种植体/应力分布/三维有限元/种植体长度Key words
orbital implant/stress distribution/three-dimensional finite element/implant length分类
医药卫生引用本文复制引用
张兴,陈松龄,张云,齐刘英..眶部种植体长度对骨界面应力影响的三维有限元研究[J].华西口腔医学杂志,2014,(5):484-487,4.基金项目
广东省科技厅社会发展基金资助项目（2010B06090007-0）；国家自然科学基金面上项目资助项目 （）
