机电工程技术Issue(5)：51-53,3.DOI:10.3969/j.issn.1009-9492.2014.05.012
基于μcos-III数控系统的研制
Development of NC System Based onμcos-III
张自谦 1黄穗 1邓丽贞1
作者信息
- 1. 广州数控设备有限公司，广东广州 510000
- 折叠
摘要
Abstract
In this paper, the μcos-III real time system is used to construct numerical control system. The modeling and running architecture of the numerical control system is briefly introduced. The data operation is executed in a critical section (by disabling interrupts and semphore), so that the data always maintain consistency. A method is proposed forμcos-III to implement a periodic task.μcos-III is successfully applied to build a embedded CNC controller, and it has been widely used in industry.关键词
μcos-III/数控系统/同步Key words
μcos-III/CNC controller/synchronization分类
信息技术与安全科学引用本文复制引用
张自谦,黄穗,邓丽贞..基于μcos-III数控系统的研制[J].机电工程技术,2014,(5):51-53,3.
