农业工程学报Issue(6)：35-41,7.DOI:10.3969/j.issn.1002-6819.2015.06.005
播种机开沟深度控制系统的设计与室内试验
Design and laboratory test of control system for depth of furrow opening
摘要
Abstract
Seeding depth is one of the indicators required by agricultural seeding technology. Seeding depth too large, too small or not consistent will cause low germination rate, slow seedling growth and other problems. It will affect late crop growth and finally reduce yield. In China, conventional tillage is widely used. But with the development of modern agricultural science and technology, the quality of soil in conventional tillage can not meet the requirements of the crop growth. Under the circumstances, conservation tillage arises in china, but the residues on surface of conservation tillage and the surface roughness is larger than conventional tillage. So working depth control is one of the keys for planter design. In order to control working depth constantly, profiling mechanism was adopted in planter for furrow opener, which was one of the most important ways to control working depth. Profiling mechanism mainly included whole profile modeling and unit profile modeling, of which whole profile modeling was simple, but the stability of its working depth was poorer. So whole profile modeling and unit profile modeling were adopted in most planter to keep working depth constantly. At present, the passive regulating mode was more used to control working depth in domestic, such as adjusting spring and parallelogram linkage. In other countries, in order to control working depth, besides the passive regulating mode, the active regulating mode was also adopted, which was controlled by electro-hydraulic technology and could realize the accurate control of working depth. Therefore, in order to improve the stability of no-till planter seeding depth, a depth of furrow opening control system was designed. The system included a surface height detection mechanism, four-connecting-rod profiling mechanism, PLC control system and hydraulic system. In the system, working depth was controlled by feedback and synchronization of profiling in real-time, the surface height by checking could reach 200 mm, and the capacity of profile modeling was 370 mm. In hydraulic system, through analyzing the work load and the speed of the system, it was determined that the rated system pressure was 10 MPa and the rated flow was 40 L/min. The average speeds of rise and fall of furrow opener were 78.7 and 102.8 mm/s, respectively. Through various tests on the depth control system, the working parameters of the control system were obtained. The system response time was 0.12 s, and working depth stability was more than 90%. In the speed of 5 km/h and working depths of 30, 50 and 70 mm, the stabilities of working depth were 90.98%, 91.45%and 92.32%, respectively, and the measurement error of the system was less than or equal to 0.54%. Therefore, it can meet the requirements of the standard on working depth stability. The research of the depth of furrow opening control system provides the reference for designing planter and understanding its furrow opening depth control mechanism.关键词
农业机械/设计/控制系统/播种机/开沟深度Key words
agriculture machinery/design/control systems/planter/depth of furrow opening分类
农业科技引用本文复制引用
赵金辉,刘立晶,杨学军,刘忠军,唐敬轩..播种机开沟深度控制系统的设计与室内试验[J].农业工程学报,2015,(6):35-41,7.基金项目
国际科技合作项目 （）
