首页|期刊导航|压力容器|奥氏体不锈钢应变强化容器变形速率的测量方法研究

奥氏体不锈钢应变强化容器变形速率的测量方法研究OACSTPCD

A Method Study on Measuring Strain Rate for Authentic Stainless Steel Coldstretched Pressure Vessels

中文摘要英文摘要

  ASME Code Case 2596针对奥氏体不锈钢应变强化的容器,要求保压阶段最大环向应变速率小于0.1%/h。研究了相关测试方法,并针对某应变强化容器,研究了在最大变形截面采用应变片测量其应变率的方法,并与传统的卷尺测量方法进行了对比分析。研究表明,在保压阶段采用贴应变片技术对应变速率测量,在技术上是可行的。

In the ASME Code Case 2596 , the maximum circumferential strain rate under coldstretched process should be less than 0 .1%/h about authentic stainless steel pressure vessels .A method that stick-ing a strain gage to the maximum deformation section of a coldstretched pressure vessel was used to meas-ure circumferential strain rate .It was also comparatively analyzed the traditional method using tapes to measure the strain rate .The research indicated …查看全部>>

章云飞;惠虎;寿比南;周伟明

华东理工大学 机械与动力工程学院,上海 200237华东理工大学 机械与动力工程学院,上海 200237中国特种设备检测研究院,北京100013全国锅炉压力容器标准化技术委员会移动分会,上海 200062

机械制造

应变强化周长应变速率应变片

coldstretchedcircumferential strain ratestrain gages

《压力容器》 2013 (5)

1-6,6

国家科技支撑计划(2011BAK06B02-04)

10.3969/j.issn.1001-4837.2013.05.001

评论

您当前未登录!去登录点击加载更多...