烟草科技2016，Vol.49Issue(4)：87-90,102,5.DOI:10.16135/j.issn1002-0861.20160414
卷烟和滤棒试样旋转方式对圆周测量的影响
Errors of circumference measurement caused by the way of rotating
摘要
Abstract
In order to promote the measurement accuracy of circumference of cigarette or filter rod sample with an irregular cross section, the effects of eccentric distance and the ratio between scanning rate and sample rotational speed on diameter measurement were analyzed following the establishment of a rotational model of irregular samples and configuration of a standard meter for circumference measurement, and four circumference meters of different types were compared. The results showed that: 1) It was proved that when sample’s rotation angle ≤0.04° in a single test run, the variation of diameter reading and absolute ovality was less than 0.001 and 0.05 mm, respectively. 2) Eccentric distance did not influence circumference measurement, but it would bring about the errors of measured maximum and minimum diameters. With reference to the eccentric distance of the four circumference meters, the possible errors of maximum and minimum diameter caused by eccentric distance were assessed, and they all fell within the tolerance range of diameter measurement.关键词
卷烟/滤棒/圆周/直径/旋转角度/偏心距离Key words
Cigarette/Filter rod/Circumference/Diameter/Rotation angle/Eccentric distance分类
轻工纺织引用本文复制引用
方婷,黄华..卷烟和滤棒试样旋转方式对圆周测量的影响[J].烟草科技,2016,49(4):87-90,102,5.基金项目
2014年度烟草行业标准制修订项目“卷烟和滤棒长度、圆周检测设备通用技术条件”（2014B004）。 （）
