表面技术2016，Vol.45Issue(5)：224-228,5.DOI:10.16490/j.cnki.issn.1001-3660.2016.05.035
内孔光整可调珩磨头的理论分析与试验研究
Theoretical Analysis and Experimental Study of an Adjustable Honing Head for Hole Finishing
摘要
Abstract
ABSTRACT:Objective At present, a honing head can only hone holes with a single size, which is poor in suitability. In order to improve the versatility of honing head and to adapt low-volume and multi-standard honing, an adjustable honing head was in-troduced.Methods Adjustment principle of this honing head was introduced. The honing force suffered by workpiece and the movement of this honing head were analyzed. The 3D modeling was built using the software SolidWorks, and the physical pro-totype which adapted to the inner diameter from 95 mm to 125 mm was manufactured. Experiments were carried out using stainless steel pipe with inner diameter of 98 mm and 106 mm respectively. After 6 minutes of honing, theRa curve and surface topography were acquired.ResultsRa decreased from 2.174μm to 0.869μm for the stainless steel pipe with inner diameter of 98 mm, andRa decreased from 1.582μm to 0.758μm for the one with inner diameter of 106 mm. The surface became smooth and bright, and the surface topography was significantly improved.Conclusion The honing head described in this article was simple and easy to use, and it could be used on general machine tool. The feasibility of this device was verified by experiments.关键词
光整加工/珩磨头/可调/珩磨力/运动分析/试验研究Key words
finishing/honing head/adjustable/honing force/motion analysis/experimental research分类
矿业与冶金引用本文复制引用
陈世彬,杨胜强,李文辉..内孔光整可调珩磨头的理论分析与试验研究[J].表面技术,2016,45(5):224-228,5.基金项目
国家自然科学基金资助项目（50675149）FundSupported by the National Natural Science Foundation of China(50675149) （50675149）
