| 注册
首页|期刊导航|物理学报|探空温度传感器的计算流体动力学分析与实验研究∗

探空温度传感器的计算流体动力学分析与实验研究∗

戴伟 刘清惓 杨杰 宿恺峰 韩上邦 施佳驰

物理学报2016,Vol.65Issue(11):114701-1-114701-11,11.
物理学报2016,Vol.65Issue(11):114701-1-114701-11,11.DOI:10.7498/aps.65.114701

探空温度传感器的计算流体动力学分析与实验研究∗

Computational fluid dynamics analysis and exp erimental study of sounding temp erature sensor

戴伟 1刘清惓 2杨杰 3宿恺峰 4韩上邦 5施佳驰1

作者信息

  • 1. 南京信息工程大学,中国气象局气溶胶与云降水重点开放实验室,南京 210044
  • 2. 南京信息工程大学大气物理学院,南京 210044
  • 3. 南京信息工程大学,江苏省大气环境与装备技术协同创新中心,南京 210044
  • 4. 南京信息工程大学,江苏省气象探测与信息处理重点实验室,南京 210044
  • 5. 南京信息工程大学电子与信息工程学院,南京 210044
  • 折叠

摘要

Abstract

Owing to the fact that the increasing amount of attention has been focused on numerical weather forecast and climate change research, it is desired that the observation error of upper air temperature with using sounding temperature sensors can be reduced down to 0.1 K. However, the temperature measurement errors of bead thermistor sounding temperature sensors, induced by solar radiation, are on the order of 1 K or more, which is a few orders of magnitude larger than the errors produced by the measurement circuits and digital signal processing systems in radiosondes. Hence, the solar radiation error poses an important bottleneck for improving the measurement accuracy. To tackle this problem, a numerical analysis method is proposed in this research. By employing a computational fluid dynamics (CFD) method, the influences of various solar radiation intensity, sensor angles, and air pressures from sea level to 20 km altitude on temperature measurement accuracy are studied. In this CFD model, the boundary conditions of external convection and solar radiation of the bead thermistor are taken into consideration. The modeling results indicate that solar radiation intensity and altitude are important factors that affect the amplitude of the radiation error. With the elevation increasing from sea level, the solar heating error appears to have an exponential correlation with the altitude, which exhibits a growing slop rate. When the sensor angle is 90◦, the radiation error of a bead thermistor sensor probe is minimal. The simulation results are fitted by a Levenberg-Marquardt method and a global optimization method. A correction equation of the radiation error is obtained, where the altitude of the sensor and solar radiation intensity act as two major variables in the equation. In order to verify the equation obtained in this study, an experimental platform for solar radiation error, which includes a low-pressure temperature chamber, a rotation apparatus, an LED-based radiation source, and a wireless communication system, is designed and constructed. It can be found that the solar radiation errors of the bead thermistor based on fluid dynamics numerical calculation are generally consistent with experimental data. The average offset and root mean square error between the correction equation and experimental results are 0.017 K and 0.023 K, respectively, which can demonstrate the accuracies of the computational fluid dynamics method, the Levenberg-Marquardt method and the global optimization method proposed in this research. The methods and techniques introduced in this paper may open the way for correcting the solar radiation errors of the bead thermistor sounding temperature sensors.

关键词

探空温度传感器/珠状热敏电阻/计算流体动力学/辐射误差

Key words

sounding temperature sensor/bead thermistor/computational fluid dynamics/radiation error

引用本文复制引用

戴伟,刘清惓,杨杰,宿恺峰,韩上邦,施佳驰..探空温度传感器的计算流体动力学分析与实验研究∗[J].物理学报,2016,65(11):114701-1-114701-11,11.

基金项目

国家公益性行业(气象)科研专项(批准号:GYHY200906037, GYHY201306079)、国家自然科学基金(批准号:41275042,61306138)和江苏高校优势学科II期建设工程资助的课题.@@@@* Project supported by the Special Scientific Research Fund of Meteorological Public Welfare Profession of China (Grant Nos. GYHY200906037, GYHY201306079), the National Natural Science Foundation of China (Grant Nos.412475042,61306138), and the Priority Academic Program Development of Jiangsu Higher Education Institutions, China (气象)

物理学报

OA北大核心CSCDCSTPCDSCI

1000-3290

访问量0
|
下载量0
段落导航相关论文