烟草科技2016，Vol.49Issue(10)：87-91,5.DOI:10.16135/j.issn1002-0861.2015.0015
SQ3X型切梗丝机砂轮磨削区域增温减黏装置的设计
Design of device for cleaning grinding wheel in stem cutter SQ3X
邵伟 1陈继富 1刘一尘1
作者信息
- 1. 安徽中烟工业有限责任公司阜阳卷烟厂，安徽省阜阳市颍河东路321号236000
- 折叠
摘要
Abstract
When the stem cutter SQ3X cut high pressure steam processed stems,sticky matter tends to adhere to the grinding wheel and results in blunt knives and unqualified cut stem thickness. Therefore,a device for cleaning the grinding wheel was designed. The said device adopted vortex tube as a heater,the hot air came out of the vortex tube dried the sticky matter and forced it to flake off the grinding wheel,proper grinder dressing was ensured. A function block of temperature control program was established in the PLC of the stem cutter to control and adjust the temperature at grinding area automatically and real-timely. The results showed that after improvement,the amount of stems adhered to the grinding wheel reduced effectively,the knife blades were well sharpened. When the temperature at grinding area was set at 80 ℃, the electric current of knife drum motor decreased from 76.2 A to 43.2 A,the qualified rate of cut stem thickness increased from 70%to 90%. The performance of stem cutter is promoted effectively.关键词
切梗丝机/砂轮/磨削/涡流管/刀片/黏附物Key words
Stem cutter/Grinding wheel/Grinding/Vortex tube/Knife blade/Sticky matter分类
轻工纺织引用本文复制引用
邵伟,陈继富,刘一尘..SQ3X型切梗丝机砂轮磨削区域增温减黏装置的设计[J].烟草科技,2016,49(10):87-91,5.
