工程设计学报2017，Vol.24Issue(2)：168-173,195,7.DOI:10.3785/j.issn.1006-754X.2017.02.007
电连接器接触件插拔特性仿真与试验研究
Simulation and experimental study on plug and pull characteristic of electrical connector contact
摘要
Abstract
In order to find the changes of each monitoring measurement in the process of plug and pull of electrical connector contacts, concerning the influence of different structure parameters on plug and pull characteristic of electric connectors,the process of plug and pull was simulated by ANSYS.The changes of jack strip deformation, stress distribution, plug and pull force and contact force were surveyed, and the change law of contact force and other parameters was analysed with different structure size of the contact.The analysis showed that the variation of the shrinkage had the noticeable influence on each monitoring measurement followed by the jack strip length and thickness, and slot width had a little effect on the contact.The results showed that the finite element method could simulate the changes of the monitoring measurement in the process of plug and pull of contact preferably.The method can provide basis for the design and reliability test of electrical connector contact.关键词
电连接器/接触件/插拔特性/有限元法/仿真Key words
electrical connector/contact/plug and pull characteristic/finite element method/simulation分类
信息技术与安全科学引用本文复制引用
骆燕燕,杨静宇,任永隆,张元磊,李文君..电连接器接触件插拔特性仿真与试验研究[J].工程设计学报,2017,24(2):168-173,195,7.基金项目
国家自然科学基金资助项目(51107028) （51107028）
河北省高等学校创新团队领军人才培育计划资助项目(LJRC003) （LJRC003）
