材料工程2017，Vol.45Issue(3)：60-65,6.DOI:10.11868/j.issn.1001-4381.2015.000098
椭球壳液压胀形过程焊缝建模方式的研究
Research on Weld Seam Models for Hydro-forming of Ellipsoidal Shell
摘要
Abstract
In order to study the effect of weld seam models on hydro-forming of ellipsoidal shell,three kinds of models,i.e.,comprehensive model rough model and no weld seam model were built and the influence was discussed on variation of axis length.An experiment for hydro-forming of ellipsoidal shell with initial axis length ratio 1.8 was first carried out,and the axis length varying with the increasing of internal pressure was obtained.Simulation on three kinds of finite element model was conducted,and the effect of weld seam models on the simulation accuracy was deeply discussed by a comparison of axis length variation between simulation and experiment.It is shown that little difference happens among the three kinds of weld seam models at the early stage of deformation,and the axis length deviation is less than 4％.However,there is worse simulation accuracy for the no weld seam model at the middle and late stage of deformation,and the axis length deviation is up to 15％.While both the comprehensive model and the rough model can successfully predict the axis length variation with the deviation no more than 5 ％.Finally,the rough model is selected on the basis of better simulation accuracy and simple weld seam model.关键词
焊缝模型/椭球壳/液压胀形Key words
weld seam model/ellipsoidal shell/hydro-forming分类
矿业与冶金引用本文复制引用
张伟玮,滕步刚..椭球壳液压胀形过程焊缝建模方式的研究[J].材料工程,2017,45(3):60-65,6.基金项目
长江学者和创新团队发展计划资助(IRT1229) （IRT1229）
