玻璃钢/复合材料Issue(6)：46-50,5.
碳纤维复合材料不同制孔工艺技术研究
STUDY ON DIFFERENT TECHNOLOGY PROCESS OF DRILLING CARBON FIBER REINFORCED PLASTICS
摘要
Abstract
Drilling induced delamination often caused the peeling at the entrance and the pushing at the exit of composite materials.Because of the thrust force being the main factor of delamination,it was necessary to control the thrust force for improving hole quality.This paper designs three different drill process consist of twist drill (with-out pilot hole),twist drill (with pilot hole) and step drill.Based on the existing axial thrust force model of these processes,the thrust force at the beginning of delamination with diameter ratio,the thrust force with hole depth and feed rate were analyzed,and the hole quality was observed by SEM.The results indicate that step drill and pilot hole can drastically decrease the thrust force and improve the hole quality.关键词
碳纤维复合材料/预制孔/阶梯钻/分层/轴向推力Key words
carbon fiber composite/pilot hole/step drill/delamination/thrust force分类
通用工业技术引用本文复制引用
王共冬,彭天,李映池,周丽,熊需海..碳纤维复合材料不同制孔工艺技术研究[J].玻璃钢/复合材料,2017,(6):46-50,5.基金项目
国家自然科学基金(51303107) （51303107）
国防“十二五”基础科研(A352* * * * * * *) （A352* * * * * * *）
