| 注册
首页|期刊导航|物理学报|基于大基模体积的10 mJ飞秒钛宝石激光再生放大器

基于大基模体积的10 mJ飞秒钛宝石激光再生放大器

杨帅帅 滕浩 何鹏 黄杭东 王兆华 董全力 魏志义

物理学报2017,Vol.66Issue(10):152-158,7.
物理学报2017,Vol.66Issue(10):152-158,7.DOI:10.7498/aps.66.104209

基于大基模体积的10 mJ飞秒钛宝石激光再生放大器

10 mJ femtosecond Ti:Sapphire regenerative amplifier with large mode size

杨帅帅 1滕浩 2何鹏 2黄杭东 3王兆华 3董全力 2魏志义1

作者信息

  • 1. 鲁东大学物理与光电工程学院,烟台260405
  • 2. 中国科学院物理研究所,北京凝聚态物理国家实验室,北京 100190
  • 3. 西安电子科技大学物理与光电工程学院,西安710126
  • 折叠

摘要

Abstract

With advent of chirped-pulse amplification,the peak power of femtosecond laser pulse was reached to petawatt (PW)or hundreds of terawatt (TW).Many progresses of high-field physics and ultrafast dynamics in matter are achieved using TW or PW laser.Pre-amplifier is an exponential growth amplifier which is also a bridge between oscillator and power amplifier.The best choice of pre-amplifier is amplification in regenerative cavity,due to its high stability and beam quality.The quality of pre-amplified laser pulse is significant to efficiency and beam quality of the successive power amplifier.High energy pre-amplifier with high beam quality will reduce the requirement of pump laser in final power amplifier.But typical regenerative amplifier only support low output energy of few millijoule.Higher energy from only one regenerative amplifier is crucial to whole laser system.High energy regenerative amplifier can be achieved by increasing the size of TEM00 in cavity.A new femtosecond Ti:sapphire regenerative amplifier with large mode size was demonstrated in this letter.The regenerative cavity is designed as stable linear resonator in which end mirrors are planar,the diameter of beam waist in Ti:sapphire crystal is larger than 2 mm,which can support high energy pulse amplified in cavity.By matching the focal spot of pump laser with the size of mode and optimization of cavity,the output laser energy up to 17.4 mJ was achieved under the pump energy of 60 mJ at repetition rate of 10 Hz,which corresponds to the efficiency of 29%.The amplified laser pulse from regenerative amplifier was compressed in a grating-pair compressor.By carefully alignment of incident angle and distance between the two gratings of compressor,the shortest pulses duration of 40.6 fs and energy of 13.9 mJ are obtained,which is a little bit longer than Fourier-transform limit based on spectrum of laser.The dispersion in the CPA laser system was also analyzed,after optimization of compressor,there are still high order dispersions uncompensated,which results in the duration of compressed pulses longer than Fourier-transform limit.Based on this large mode size regenerative amplifier,peak power of 1.9 TW laser pulses which compressed pulse energy of 81.4 mJ in 43 fs were also further realized by following only one stage of multipass amplifier.The beam quality (M2) was measured to be 1.6 and 1.5 in X and Y directions respectively,and the energy stability is 2.15% (rms).The results show that this large mode size regenerative amplifier is an ideal choice of pre-amplifier in TW laser system.

关键词

飞秒激光/啁啾脉冲放大/再生放大器/太瓦

Key words

femtosecond laser/chirped-pulse amplification/regenerative amplifier/terawatt

引用本文复制引用

杨帅帅,滕浩,何鹏,黄杭东,王兆华,董全力,魏志义..基于大基模体积的10 mJ飞秒钛宝石激光再生放大器[J].物理学报,2017,66(10):152-158,7.

基金项目

国家重大科学仪器设备开发专项基金(批准号:2012YQ12004701)、国家重点基础研究发展计划(批准号:2013CB922401)和国家自然科学基金(批准号:11474002,11674386)资助的课题.Project supported by the Special Foundation of State Major Scientific Instrument and Equipment Development of China (Grant No.2012YQ12004701),the State Key Development Program for Basic Research of China (Grant No.2013CB922401),and the National Natural Science Foundation of China (Grant Nos.11474002,11674386). (批准号:2012YQ12004701)

物理学报

OA北大核心CSCDCSTPCDSCI

1000-3290

访问量4
|
下载量0
段落导航相关论文