机械科学与技术2017，Vol.36Issue(11)：1754-1758,5.DOI:10.13433/j.cnki.1003-8728.2017.1119
针对奥贝球铁高速铣削力的表面粗糙度建模的实验研究
Correlation Model between Surface Roughness and Milling Force and Experiments for High Speed Milling of Austempered Ductile Iron
摘要
Abstract
Austempered ductile iron (ADI) is a difficult machining material with excellent comprehensive properties,and its high speed milling force has an important influence on surface roughness of the work-piece.Based on the combined mechanical properties,the multi-factor orthogonal regression experiment theory is applied to establish the relationship between the milling force and the surface roughness.In the experiment,the spindle speed,feed per tooth rate,cutting depth and cutting width are regarded as the multi factors,and the milling force and surface roughness are regarded as the dependent variables.With the least squares method,a model of the milling force and the surface roughness about the three components (Fx,Fy,Fz) is established,and the significance of the regression model and its coefficient analysis are conducted to verify the model and the influence level of three components(Fx,Fy,Fz) of the milling force.Finally,some verification experiments are designed to check the effectiveness of the experimental model.The experimental results show that the influence order of the three force components on the surface roughness is in turn:tangential force,axial force,radial force.The verification experiments prove the credibility and validity of the model,and it will provide an important theoretical support and technical guidance in high-speed milling process of ADI.关键词
奥贝球铁/高速铣削力/表面粗糙度/正交回归实验/最小二乘法Key words
austempered ductile iron/high speed milling force/surface roughness/orthogonal regression experiment/least squares method分类
信息技术与安全科学引用本文复制引用
胡斌梁,张朝星,康辉民,许功元,刘艳余..针对奥贝球铁高速铣削力的表面粗糙度建模的实验研究[J].机械科学与技术,2017,36(11):1754-1758,5.基金项目
国家自然科学基金项目(61272196)、湖南省教育厅重点项目(15A063)及湖南省青年基金项目(12B042)资助 （61272196）
