材料与冶金学报2018，Vol.17Issue(1)：26-31,6.DOI:10.14186/j.cnki.1671-6620.2018.01.005
吹氩连铸结晶器内渣眼形成的水模型实验
A water model of slag eye formation in a continuous casting mold with argon injection
摘要
Abstract
In view of the argon injection process in the continuous casting mold, a water model experiment on formation of the slag eye on the top surface of the mold was carried out by changing parameters such as the casting speed,gas flow speed and slag thickness. It was found there are two typical slag eye distributions: one is around the nozzle;the other is around the narrow wall. The results showed that,with increasing the casting speed,area of the slag eye around the narrow wall increases, area of the slag eye around nozzle decreases, the total area of the slag eyes increases. As gas flow speed increases,area of the slag eye around the narrow wall decreases,area of the slag eye around nozzle increases,the total area of the slag eyes decreases first and then increases. With increasing the thickness of the slag layer,both the area of the slag eyes around narrow wall and nozzle decreases.关键词
连铸结晶器/吹氩/渣眼/水模型实验Key words
continuous casting mold/argon injection/slag eye/water model experiment分类
矿业与冶金引用本文复制引用
刘中秋,庞世超,李宝宽..吹氩连铸结晶器内渣眼形成的水模型实验[J].材料与冶金学报,2018,17(1):26-31,6.基金项目
国家自然科学基金(51604070)和中央高校基本科研业务费资助(N162504009) （51604070）
