石墨密封组件波形弹簧回弹仿真性能分析OA
该文采用ABAQUS搭载动力显式计算仿真法,对GH738 波形弹簧的成形以及卸载回弹进行研究后发现,在设计总高为 8 mm,波数N=3 的波形弹簧如采用基于原高度所设计的液压模,回弹量为 2.165 mm.峰谷过渡段区域在卸载后所表现出的回弹量相比波峰更大,而波峰波谷在回弹后依然保持部分弯曲,这是由于过渡段塑性变形区面积更小所致.此外,波簧的回弹量与板材厚度息息相关,随着厚度的增加,成形过程中表现出更大的回弹量,这是由于截面厚度增加导致弹性区变大…查看全部>>
In this paper,the dynamic explicit calculation simulation method of Abaqus is used to study the forming and unloading rebound of GH738 waveform spring.It is found that if the total design height of the wave spring is 8 mm and the wavenumber N is 3,the rebound of the hydraulic die based on the original height is 2.165 mm.After unloading,the rebound of the peak-valley transition section is larger than that of the wave peak,while the peak and trough still keep …查看全部>>
张冰波
空装驻保定地区军事代表室,河北 保定 071000
机械工程
高温合金波形弹簧动力显式有限元回弹量板材厚度
superalloycorrugated springdynamic explicit finite elementreboundplate thickness
《科技创新与应用》 2024 (3)
57-60,4
评论