焊管2024，Vol.47Issue(3)：53-57,5.DOI:10.19291/j.cnki.1001-3938.2024.03.008
UOE焊管机组铣边机刀盘转速计算模型及铣削参数分析
Analysis of Calculation Model and Milling Parameter of the Cutter Head Speed of UOE Welding Unit Edge Milling Machine
黄杰 1徐根涛1
作者信息
- 1. 宝山钢铁股份有限公司,上海 201900
- 折叠
摘要
Abstract
In order to set the milling parameters reasonably and improve the production of the edge miller,a calculation model of the cutter head speed of the UOE large diameter straight welded pipe milling machine is published,and the calculation results of the model are compared with the actual production data.The verification results show that the calculated parameters are basically consistent with the actual parameters during production.According to the model calculation formula,the influence of milling thickness and milling line speed on the speed of the clamp car was analyzed using Matlab calculation software.The analysis showed that there was a linear positive correlation between milling thickness,milling line speed,and the speed of the clamp car.关键词
UOE焊管机组/铣边机/铣削线速度/铣削厚度/夹钳小车速度Key words
UOE welding unit/edge milling machine/milling line speed/milling thickness/the speed of the clamp car分类
矿业与冶金引用本文复制引用
黄杰,徐根涛..UOE焊管机组铣边机刀盘转速计算模型及铣削参数分析[J].焊管,2024,47(3):53-57,5.
