| 注册
首页|期刊导航|湖南大学学报(自然科学版)|抛浆除鳞工艺中氧化皮去除模型研究

抛浆除鳞工艺中氧化皮去除模型研究

柴泽琳 周存龙 郭瑞 姜正义

湖南大学学报(自然科学版)2024,Vol.51Issue(4):114-122,9.
湖南大学学报(自然科学版)2024,Vol.51Issue(4):114-122,9.DOI:10.16339/j.cnki.hdxbzkb.2024177

抛浆除鳞工艺中氧化皮去除模型研究

Study on Model of Oxide Scale Removal in Slurry Blasting Process

柴泽琳 1周存龙 1郭瑞 1姜正义2

作者信息

  • 1. 太原科技大学 机械工程学院,山西 太原 030024
  • 2. 伍伦贡大学,澳大利亚 伍伦贡 NSW2522
  • 折叠

摘要

Abstract

Because of the lack of an accurate mathematical model of oxide scale removal and process parameters in slurry blasting,the oxide scale of the Q235 hot rolled strip is taken as the research object in this article.According to the energy conservation principle,the kinetic energy change law of the mixed slurry of abrasive particles and water in the slurry blasting process during the impact was analyzed.The strain energy change law of the oxide scale on the surface of the matrix after the slurry blast was analyzed based on the strain energy theory,the mathematical model between the oxide scale removal amount and the slurry blasting process parameters was established,and the finite element ANSYS/AUTODYN module and smooth particle hydrodynamics are used to simulate the process of oxide scale and matrix deformation during the slurry blasting process.Finally,the integrated descaling test platform is used to carry out the slurry descaling test.The results show that the oxide scale cracks and peels off when the oxide scale strain on the substrate surface is higher than the critical strain,the ratio of the influence of abrasive particle size on the increase rate of impact range to the impact velocity is 105.35%∶24.14%,the ratio of the influence of abrasive particle size on the increase rate of impact depth to the impact velocity is 233.67%∶5.86%,the maximum deviation rate between the finite element calculation and experimental results in the impact range is 8.71%,and the maximum deviation rate of impact depth is 8.55%.The finite element calculation results are consistent with the experimental results,and the model applicability is verified by the results of 304 stainless steel and 45 steel slurry descaling tests.

关键词

抛浆/应变/去除量/冲击深度/冲击范围

Key words

slurry blasting/strain/removal/impact depth/impact range

分类

矿业与冶金

引用本文复制引用

柴泽琳,周存龙,郭瑞,姜正义..抛浆除鳞工艺中氧化皮去除模型研究[J].湖南大学学报(自然科学版),2024,51(4):114-122,9.

基金项目

国家自然科学基金资助项目(52375361),National Natural Science Foundation of China(52375361) (52375361)

中央引导地方发展项目(Z135050009017),Central Guidance for Local Scientific and Technological Development Funds(Z135050009017) (Z135050009017)

湖南大学学报(自然科学版)

OA北大核心CSTPCD

1674-2974

访问量3
|
下载量0
段落导航相关论文