木材科学与技术2024，Vol.38Issue(3)：49-55,7.DOI:10.12326/j.2096-9694.2024043
毛竹热解油改性光敏树脂光固化3D打印优化研究
Optimizing Photocuring 3D Printing of Moso Bamboo Pyrolytic Oil Modified Photosensitive Resin
摘要
Abstract
Photosensitive resin is an important raw material for photocuring 3D printing,which most of them are derived from high-cost non-renewable petrochemical resources.Therefore,there is an urgent need to develop novel green and low-cost photosensitive resin materials and optimize their 3D printing process.In this study,moso bamboo(Phyllostachys edulis)pyrolytic oil was used as the raw material to synthesize bio-oil polyurethane acrylate(BPUA)photosensitive resin.The parameters of the BPUA resin for photocuring 3D printing were optimized as following:the exposure time of 5 seconds,the thickness of the sliced layer of 0.05 mm,and the number of the bottom layer of seven.Under this condition,good mechanical properties were achieved with a tensile strength of 21.94 MPa,a fracture strength of 17.55%,and a hardness of 76.6 HD.Several planar and three-dimensional structural models were successfully printed with the optimized process parameters showing high dimensional accuracy and good surface quality as indicated by the microscopic and chemical analyses.关键词
光固化3D打印/毛竹热解油/光敏树脂/聚氨酯丙烯酸酯/工艺参数Key words
photocuring 3D printing/moso bamboo pyrolytic oil/photosensitive resin/polyurethane acrylate/process parameters分类
农业科技引用本文复制引用
朱琳,李永霞,任学勇,林涛..毛竹热解油改性光敏树脂光固化3D打印优化研究[J].木材科学与技术,2024,38(3):49-55,7.基金项目
"十四五"国家重点研发计划项目课题"竹藤材流态化清洁热解技术"(2022YFD2200904) （2022YFD2200904）
中央财政林业科技推广项目"林果废弃物热裂解炼制活性炭技术推广示范"(冀TG[2022]004). （冀TG[2022]004）
