| 注册
首页|期刊导航|西南交通大学学报|轮对升降速工况下短信号拼接定速信号的方法

轮对升降速工况下短信号拼接定速信号的方法

张伟 董大伟 黄燕 闫兵 华春蓉 吕路梅 宋世哲

西南交通大学学报2024,Vol.59Issue(6):1346-1356,11.
西南交通大学学报2024,Vol.59Issue(6):1346-1356,11.DOI:10.3969/j.issn.0258-2724.20220523

轮对升降速工况下短信号拼接定速信号的方法

Method of Splicing Constant Speed Signals with Short Signals During Wheelset Acceleration and Deceleration

张伟 1董大伟 1黄燕 1闫兵 1华春蓉 1吕路梅 1宋世哲1

作者信息

  • 1. 西南交通大学机械工程学院,四川 成都 610031
  • 折叠

摘要

Abstract

The characteristic value of train wheelsets is closely related to the speed,and the quantitative analysis of wheelset faults requires signals with a certain length collected at a certain speed.However,such a signal is difficult to be obtained by the system working in the variable speed condition.Therefore,a signal reconstruction method that did not require any velocimeters was proposed to realize the above quantitative analysis.This method used short signal segments to splice the constant speed signals under the acceleration and deceleration conditions.Firstly,a short-time Fourier transform(STFT)peak search method was adopted to obtain the speed curve and extract multiple signal segments passing through a specified speed.Secondly,the signal segments were converted into an angular domain signal,and the phase difference between signals was determined by cross-power spectra density(CPSD).Then,according to the phase difference and the length of the front signal,the splicing position of signals was obtained,and interpolation and fusion techniques were used to ensure the continuity of spliced signals.Finally,the spliced angular domain signal was resampled into the time domain signal.A rotor test bench with a similar wheelset structure has verified that during acceleration and deceleration of a cracked shaft,the frequency spectrums of the spliced signals of each speed obtained by this method are highly close to the frequency spectrums of the constant speed signals obtained by the experiment.The relative errors of the 1x and 3x values between the spliced signal of 15.0 Hz and the constant speed signal are only 0.9%and 1.0%,respectively.After adding noise to the signals to be spliced and shortening them to 1.5 cycles,the splicing phase error does not exceed 10°.

关键词

定速信号/升降速工况/角域信号/互功率谱密度/转速计/信号重构

Key words

constant speed signals/acceleration and deceleration conditions/angle domain signal/cross-power spectra density(CPSD)/velocimeters/signal reconstruction

分类

机械工程

引用本文复制引用

张伟,董大伟,黄燕,闫兵,华春蓉,吕路梅,宋世哲..轮对升降速工况下短信号拼接定速信号的方法[J].西南交通大学学报,2024,59(6):1346-1356,11.

基金项目

国家自然科学基金项目(51875482) (51875482)

西南交通大学学报

OA北大核心CSTPCD

0258-2724

访问量0
|
下载量0
段落导航相关论文