中国机械工程2025，Vol.36Issue(4)：688-696,9.DOI:10.3969/j.issn.1004-132X.2025.04.005
基于参数映射的开式整体叶盘流道铣削路径生成方法
Generation Method of Milling Paths of Open Blisk Channels Based on Parameter Mapping
摘要
Abstract
A machining strategy for variable layer thickness with layered surfaces was proposed to address the rough machining issues of the channels across the entire blisk components.Considering the characteristics of the variation in the width of the channels across the entire blisk components,the geodesic offset was used to determine the toolpath boundaries on both sides of the channels,and the step size and the number of paths were determined.A planning method for the longitudinal milling path along the channels was proposed,and then the tool axis vector of the channel boundaries is calcu-lated,and the tool axis vector of the middle cutter positions of the channel boundaries is calculated by quaternion interpolation.The calculation results show that,compared with the conventional uniform layering method using the blisk hub rotary surface offset or the blisk covering rotary surface offset,the variable layer thickness surface delamination may better adapt to the surface changes from the cov-ered rotary surface to the hub rotary surface,the surface quality of the blades is ensured,with the ad-vantage of a uniform machined blade surface allowance,and the feasibility of the algorithm was veri-fied through machining examples.关键词
开式整体叶盘/曲面分层/测地偏移/粗加工/刀位规划Key words
open blisk/surface layering/geodetic offset/roughing/tool path planning分类
机械工程引用本文复制引用
韩江,张文强,田晓青,夏链..基于参数映射的开式整体叶盘流道铣削路径生成方法[J].中国机械工程,2025,36(4):688-696,9.基金项目
国家重点研发计划(2022YFA1005204) （2022YFA1005204）
