机电工程技术2025，Vol.54Issue(10)：22-26,88,6.DOI:10.3969/j.issn.1009-9492.2025.10.005
门式卡车扫描站小体积刻度模型的设计与验证
Design and Verification of Small-volume Scale Model of Frame Truck Scanning Station
摘要
Abstract
Truck scanning station passes the mine car through the gantry without stopping,the detector above the gantry measures the energy spectrum count rate generated by the ore in the mine car and analyzes the average uranium/thorium content of the ore.However,since the ore transportation volume of large mine cars exceeds 300 t,it is difficult to build a standard device for direct measurement based on the ore measurement conditions of the mine cars so that the measurement characteristic parameters do not change with time and the environment.In response to this problem,a small reference source is used instead of a large device to conduct calibration technology research,the intrinsic detection performance parameters of the detector of the mine car portal scanning station is calibrated,and then the Monte Carlo simulation method is used to simulate the detector pair of the mine car portal scanning station.Referring to the response of the source and the entire vehicle ore,a theoretical conversion relationship between the two is established,thereby establishing a theoretical model of passive efficiency scale.The verification results show that the relative error between the small-volume calibration model of the gantry truck scanning station and the on-site calibration results is less than 0.52%,proving the effectiveness and accuracy of the method.关键词
卡车扫描站/刻度/模拟/模型/铀矿Key words
truck scanning station/scale/simulation/model/uranium ore分类
机械工程引用本文复制引用
董文明,陈锐,王仁波,张雄杰,邓星星..门式卡车扫描站小体积刻度模型的设计与验证[J].机电工程技术,2025,54(10):22-26,88,6.基金项目
江西省自然科学基金项目(20202BABL201025) （20202BABL201025）
横向课题项目(019-GN-B-2021-C45-P.T.99-00025) （019-GN-B-2021-C45-P.T.99-00025）
