| 注册
首页|期刊导航|排灌机械工程学报|矿浆输送中隔膜泵动态特性及阀滞后性

矿浆输送中隔膜泵动态特性及阀滞后性

韩世昌 申哲 李妍 解天华

排灌机械工程学报2025,Vol.43Issue(6):558-564,7.
排灌机械工程学报2025,Vol.43Issue(6):558-564,7.DOI:10.3969/j.issn.1674-8530.23.0240

矿浆输送中隔膜泵动态特性及阀滞后性

Dynamic characteristics and valve hysteresis of diaphragm pump in slurry transportation

韩世昌 1申哲 1李妍 2解天华2

作者信息

  • 1. 昆明理工大学机电工程学院,云南 昆明 650500||昆明理工大学云南先进装备智能控制与应用国际联合实验室,云南 昆明 650500
  • 2. 云南大红山管道有限公司,云南 玉溪 653405
  • 折叠

摘要

Abstract

In order to analyze the dynamic characteristics of diaphragm pumps in the context of slurry pipeline transportation,the GEHO TZPM1600 diaphragm pump was selected as the research subject.A mechanical-hydraulic joint simulation model for the diaphragm pump was established,and the effects of different crank speeds on the dynamic characteristics of the diaphragm pump was analyzed.Additionally,the effects of parameters such as crank speed,crank length,and pump inlet pressure on the opening and closing hysteresis times of the suction and discharge valves were examined.The analy-sis indicates that the changes in crank speed significantly influence the dynamic characteristics of the discharge valve.When the crank speed increases from 10 r/min to 30 r/min,the maximum opening speed of the discharge valve increases by 9.449 m/s,the maximum closing speed increases by 0.945 m/s,the maximum increase of the valve flow rate pulsations is 17 220.0 L/min,and the maximum in-crease in backflow rate is 1 071.5 L/min.The opening and closing hysteresis times of the suction and discharge valves are primarily influenced by crank speed,crank length,and pump inlet pressure.The opening hysteresis time of the suction valve is more strongly affected by the crank speed,with an in-crease in speed reducing the opening hysteresis time by 0.117 s.The closing hysteresis time is more susceptible to the influence of crank length and pump inlet pressure,with the hysteresis time increasing by 0.261 s as the crank length increases.Changes in crank speed,crank length,and pump inlet pres-sure mainly affect the opening hysteresis time of the discharge valve.The research findings provide guidance for the technological improvement of diaphragm pumps in slurry transportation systems.

关键词

矿浆输送/隔膜泵/联合仿真/动态特性/滞后时间

Key words

slurry transportation/diaphragm pump/joint simulation/dynamic characteristics/hysteresis time

分类

农业工程

引用本文复制引用

韩世昌,申哲,李妍,解天华..矿浆输送中隔膜泵动态特性及阀滞后性[J].排灌机械工程学报,2025,43(6):558-564,7.

基金项目

云南省科技厅科技计划项目(202001AU070032) (202001AU070032)

排灌机械工程学报

OA北大核心

1674-8530

访问量0
|
下载量0
段落导航相关论文