| 注册
首页|期刊导航|东华大学学报(英文版)|低温磷酸水溶液部分溶解木浆制备全纤维素复合材料

低温磷酸水溶液部分溶解木浆制备全纤维素复合材料

METASEBIA Gizaw 王碧佳 冯雪凌 荣立夺

东华大学学报(英文版)2025,Vol.42Issue(4):380-390,11.
东华大学学报(英文版)2025,Vol.42Issue(4):380-390,11.DOI:10.19884/j.1672-5220.202408001

低温磷酸水溶液部分溶解木浆制备全纤维素复合材料

All-Cellulose Composites Fabricated by Partially Dissolving Wood Pulp in Cryogenic Aqueous Phosphoric Acid

METASEBIA Gizaw 1王碧佳 2冯雪凌 2荣立夺2

作者信息

  • 1. 东华大学化学与化工学院,上海 201620
  • 2. 东华大学化学与化工学院,上海 201620||东华大学国家染整工程技术研究中心,上海 201620
  • 折叠

摘要

Abstract

All-cellulose composites(ACCs)are composites that use non-derivatized cellulose as both the matrix and the reinforcement phase.ACC consists entirely of cellulose,and since the reinforcement phase and the matrix have exactly the same chemical properties,they can overcome the problem of poor fiber-matrix adhesion in biocomposites.In this study,ACC was prepared by partially dissolving wood pulp in a cryogenic aqueous phosphoric acid solution,and the effects of dissolution temperature,dissolution time and pressing load on the properties of ACC were investigated.The results showed that a dissolution time of 45 min achieved the optimal reinforcement-matrix ratio.The use of an aqueous ethanol solution at an ethanol mass fraction of 50%as a coagulation bath and a pressing load of 3 000 kg during the drying process achieved the best mechanical properties of ACC,with a tensile strength of 49.3 MPa(approximately 210%higher than that of the untreated wood pulp)and an elastic modulus of 1.6 GPa(approximately 122%higher than that of the untreated wood pulp).The composite's compactness affected ACC's mechanical properties.The air permeability analysis showed that the barrier performance of ACC was also significantly better than that of the untreated wood pulp.With a pressing load of 3 500 kg,the surface water contact angle(WCA)increased to 110.3°(approximately 94%higher than that of the untreated wood pulp),and the air permeability was significantly reduced to 1.1 mm/s,showing its good application prospects in the field of green packaging materials.

关键词

纤维素/全纤维素复合材料/低温磷酸/部分溶解/可持续材料

Key words

cellulose/all-cellulose composite(ACC)/cryogenic phosphoric acid/partial dissolution(PD)/sustainable material

分类

通用工业技术

引用本文复制引用

METASEBIA Gizaw,王碧佳,冯雪凌,荣立夺..低温磷酸水溶液部分溶解木浆制备全纤维素复合材料[J].东华大学学报(英文版),2025,42(4):380-390,11.

基金项目

Fundamental Research Funds for the Central Universities,China(No.2232023G-04) (No.2232023G-04)

东华大学学报(英文版)

1672-5220

访问量0
|
下载量0
段落导航相关论文