| 注册
首页|期刊导航|重庆大学学报|蜂窝梁残余应力试验

蜂窝梁残余应力试验

李井超 周绪红 何子奇 陈鹏

重庆大学学报2025,Vol.48Issue(9):93-103,11.
重庆大学学报2025,Vol.48Issue(9):93-103,11.DOI:10.11835/j.issn.1000-582X.2025.09.009

蜂窝梁残余应力试验

Residual stress experiment on castellated beams

李井超 1周绪红 2何子奇 2陈鹏3

作者信息

  • 1. 湖南城市学院 土木工程学院,湖南 益阳 410082
  • 2. 重庆大学 土木工程学院,重庆 400045
  • 3. 中国建筑西南设计研究院有限公司,成都 610041
  • 折叠

摘要

Abstract

Castellated beams are a new type of structural member fabricated by cutting the web of an I-section or H-sectionmember along with the polygonal lines and then welding the upper and lower halves together.Compared to the traditional solid-web beams,castellated beams exhibit the advantages of a high strength-to-weight ratio,high in-plane stiffness,and economic efficiency.Due to the increased depth and the presence of openings,castellated beams are more susceptible to buckling.Studies have shown that the distribution of residual stresses across the section significantly influences their overall stability behavior.In this study,the residual stress distribution of two solid beams,four beams with low-height web plates,and four castellated beam specimens was measured using the sectioning method to investigate the influence of the cutting and welding processes on the residual stresses in the castellated beam sections.Test results indicate that the shape of the flange residual stress distribution remains largely unchanged after cutting and welding,but the tensile residual stress at the flange-web junction increases significantly,and it can achieve the yield strength after welding.The web cut region in the shallow and deep web specimens exhibit high levels of tensile residual stress.The residual stress distribution in the T-section of castellated beams is similar to that of the short and deep web specimens,while the web post section in castellated beams exhibits changes due to welding,with tensile residual stresses reaching yield strength at the welds.Based on the analysis of test results and existing models,a simplified model for longitudinal residual stress distribution was proposed for castellated beams,which could provide a reference for the stability analysis and design of castellated beams.

关键词

蜂窝梁/切割/焊接/残余应力/分布模型

Key words

castellated beams/cutting/welding/residual stress/distribution model

分类

建筑与水利

引用本文复制引用

李井超,周绪红,何子奇,陈鹏..蜂窝梁残余应力试验[J].重庆大学学报,2025,48(9):93-103,11.

基金项目

湖南省自然科学基金项目(2020JJ5020) (2020JJ5020)

湖南省教育厅科学研究项目(24C0443).Supported by the Natural Science Foundation Project of Hunan Province(2020JJ5020),and the Scientific Research Project of Hunan Provincial Department of Education(24C0443). (24C0443)

重庆大学学报

OA北大核心

1000-582X

访问量0
|
下载量0
段落导航相关论文