| 注册
首页|期刊导航|焊管|高温过热器T91/TP347H异种钢焊接接头早期失效分析

高温过热器T91/TP347H异种钢焊接接头早期失效分析

邓建斌 黎俊良 廖方华 王治国 何亮 刘福广 王齐宏 房军

焊管2026,Vol.49Issue(1):75-81,7.
焊管2026,Vol.49Issue(1):75-81,7.DOI:10.19291/j.cnki.1001-3938.2026.01.009

高温过热器T91/TP347H异种钢焊接接头早期失效分析

Early Failure Analysis for Dissimilar Steel Welded Joints of High-temperature Superheater T91/TP347H

邓建斌 1黎俊良 2廖方华 1王治国 1何亮 3刘福广 2王齐宏 1房军3

作者信息

  • 1. 广东大唐国际潮州发电有限责任公司,广东 潮州 515723
  • 2. 西安热工研究院有限公司,西安 710032
  • 3. 呼和浩特科林热电有限责任公司,呼和浩特 010030
  • 折叠

摘要

Abstract

In response of the cracking and failure problem of heterogeneous steel welding joint of T91/TP347H in a 1 000 MW ultra-high temperature superheater of a certain power plant,methods such as chemical composition analysis,microstructure observation and mechanical property testing were adopted to analyze the failure causes.The results show that the weld size of T91/TP347H heterogeneous steel,the chemical composition of the base metal on both sides,and the tensile strength of the joint all meet the standard requirements.The microstructure on the T91 side of the welding joint is lath martensite,the weld is γ-Ni austenite,and the TP347H side is γ-Fe austenite.There is an oxide layer 87 to 89.51 μm thick on the inner and outer walls of the T91 side.Oxidation notches and cracks are observed at the weld interface of T91/TP347H,with a large amount of M23C6 second phase rich in C,Cr,Mo,Ni,and V and creep voids concentrated at the crack tip.The peak hardness of the heat affected zone on the T91 side is 331 HV1.0,which exceeds the standard value.The main cause of the failure of the T91/TP347H heterogeneous steel welding joint is the improper post-weld heat treatment process of the joint itself,which leads to a relatively high hardness in the heat affected zone.Coupled with the complex superimposition and synergy of welding stress and service stress at the heterogeneous steel interface,as well as the creep of the material itself during long-term high-temperature service,the early failure of the heterogeneous steel joint is ultimately caused.

关键词

异种钢焊接接头/T91/TP347H/失效/氧化缺口/第二相

Key words

dissimilar steel welded joint/T91/TP347H/failure/oxidation notch/the second phase

分类

矿业与冶金

引用本文复制引用

邓建斌,黎俊良,廖方华,王治国,何亮,刘福广,王齐宏,房军..高温过热器T91/TP347H异种钢焊接接头早期失效分析[J].焊管,2026,49(1):75-81,7.

基金项目

广东大唐国际潮州发电有限责任公司基础性前瞻性科技专项"1000MW锅炉末级过热器异种钢焊接接头状态评估及治理"(项目编号CDTHT20240032534). (项目编号CDTHT20240032534)

焊管

1001-3938

访问量0
|
下载量0
段落导航相关论文