测试科学与仪器2026，Vol.17Issue(2)：307-319,13.DOI:10.62756/jmsi.1674-8042.2026026
基于EWT和改进ConvNeXt网络的故障诊断方法
Fault diagnosis method based on EWT and improved ConvNeXt networks
摘要
Abstract
Due to the interference of strong noise,feature extraction faces the challenge of limited information,which is not conducive to motor equipment fault diagnosis.This paper proposes a fault diagnosis method based on the empirical wavelet transform(EWT)and an improved ConvNeXt network.The modal components were extracted from the signals of different sensors using empirical wavelet transform,noise was removed,and then the signals were reconstructed.Secondly,the short-time Fourier transform(STFT)was used to convert the one-dimensional signal after noise reduction and reconstruction into a two-dimensional time-frequency spectrum image that enhanced signal features.Single-channel images generated by a single sensor were fused to form multi-channel images,thereby boosting the feature extraction capability of the ConvNeXt network.Additionally,the Ghost convolution module and the efficient local attention mechanism(ELA)were introduced into the ConvNeXt-T(ConvNeXt-Tiny)network,further enhancing the network's performance.Experimental validation was conducted on application examples of various fault diagnostic devices,and comparisons were made with existing mainstream deep learning methods such as SE-InceptionV3,CBAM-ResNet,and CNN-LSTM etc.Experimental results confirmed under different noise environments and variable operating conditions,the proposed method achieved better diagnostic accuracy and enhanced generalization performance.关键词
故障诊断/ConvNeXt/经验小波变换/短时傅里叶变换/高效局部注意力机制/数据级融合Key words
fault diagnosis/ConvNeXt/empirical wavelet transform/short-time fourier-transformation/efficient local attention/data level fusion引用本文复制引用
李军,马轶..基于EWT和改进ConvNeXt网络的故障诊断方法[J].测试科学与仪器,2026,17(2):307-319,13.基金项目
This work was supported by the National Natural Science Foundation of China(No.12172157),the Key Project of Natural Science Foundation of Gansu Province(No.25JRRA150),and Lanzhou Science and Technology Plan Project(No.2023-1-16). （No.12172157）
