爆破器材2026，Vol.55Issue(3)：24-29,6.DOI:10.3969/j.issn.1001-8352.2026.03.004
基于高浓度浆料的模压可燃药筒的制备与性能
Preparation and Performances of Molded Combustible Cartridge Cases Based on High-Concentration Slurry
艾光麾 1赵洪波 2李忠山 2宋育芳 3肖乐勤 1周伟良1
作者信息
- 1. 南京理工大学化学与化工学院(江苏 南京,210094)
- 2. 西安北方惠安化学工业有限公司(陕西 西安,710302)
- 3. 中国人民警察大学防火工程学院(河北 廊坊,065000)
- 折叠
摘要
Abstract
To improve production efficiency and reduce wastewater discharge in the vacuum filtration molding process for manufacturing combustible cartridge cases,an ionic dispersant was added to the slurry.When the mass fraction of slurry was increased from 0.5%to 1.0%,the sedimentation speed of the slurry decreased by nearly half.The mechani-cal and combustion properties of molded combustible cartridge cases with increased slurry mass fraction were investigated by vacuum-filtered wet preforms,hot-press forming,and constant-volume combustion tests.Wet preforms prepared from the dispersant-stabilized slurry exhibits improved mass uniformity.The mechanical properties of the molded combustile cartridge cases are comparable to those produced by the current process,and combustion behavior remains normal.These indicate that raising the slurry mass fractions can increase production efficiency and reduce wastewater generation while maintaining the quality of molded combustible cartridge cases.关键词
模压可燃药筒/高浓度浆料/分散剂/浆料分散Key words
molded combustible cartridge case/high-concentration slurry/dispersant/slurry dispersion分类
化学化工引用本文复制引用
艾光麾,赵洪波,李忠山,宋育芳,肖乐勤,周伟良..基于高浓度浆料的模压可燃药筒的制备与性能[J].爆破器材,2026,55(3):24-29,6.
