| 注册
首页|期刊导航|西南交通大学学报|MW级电磁轴承高速永磁电机空气摩擦损耗特性研究

MW级电磁轴承高速永磁电机空气摩擦损耗特性研究

李伟 祝长生

西南交通大学学报2026,Vol.61Issue(4):1179-1188,10.
✕
西南交通大学学报2026,Vol.61Issue(4):1179-1188,10.DOI:10.3969/j.issn.0258-2724.20250544

MW级电磁轴承高速永磁电机空气摩擦损耗特性研究

Study on Air Friction Loss Characteristics of MW-Class High-Speed Permanent Magnet Motor with Magnetic Bearings

李伟 1祝长生1

作者信息

  • 1. 浙江大学电气工程学院,浙江 杭州 310027
  • 折叠

摘要

Abstract

The air friction loss of a motor rotor increases rapidly with the increase in rotational speed.Especially for a high-speed motor supported by magnetic bearings,since the air-gap structure is complex,mastering its air friction loss characteristics is particularly important.A 2 MW、15 000 r/min high-speed permanent magnet motor with magnetic bearings was taken as the research object,and the entire air domain inside the motor was modeled.Firstly,based on the fine simulation technology of computational fluid dynamics(CFD),the distribution characteristics of air friction loss on the rotor surface were obtained.Then,the effects of rotational speed,ventilation wind speed,surface roughness height,air gap structure,and rotor eccentricity on the air friction loss characteristics of the rotor were analyzed in detail.Finally,a dual-motor drag test was conducted,and the air friction loss of the rotor was obtained by the loss separation method.The research results indicate that the air friction loss of the rotor is mainly concentrated in the air gap of the motor.At a rotational speed of 15 000 r/min and a ventilation wind speed of 2.5 m/s,it accounts for approximately 70.1%of the total air friction loss.Meanwhile,the air friction loss at the thrust collar cannot be ignored,accounting for about 23.9%of the total air friction loss under the non-ventilation condition.The synergistic thermal effect of cooling enhancement and loss increase caused by ventilation needs to be comprehensively considered.When the ventilation wind speed increases from 2.5 m/s to 5.0 m/s,the cooling heat transfer coefficient on the rotor surface increases from 315.7 W/(m2•℃)to 469.1 W/(m2•℃),and the air friction loss also increases by 3.13 kW.The maximum error between the experimentally measured values and the simulation calculation results is 8.60%.

关键词

高速永磁电机/空气摩擦损耗/计算流体力学/主动磁轴承

Key words

high-speed permanent magnet motor/air friction loss/computational fluid dynamics/active magnetic bearing(AMB)

分类

信息技术与安全科学

引用本文复制引用

李伟,祝长生..MW级电磁轴承高速永磁电机空气摩擦损耗特性研究[J].西南交通大学学报,2026,61(4):1179-1188,10.

基金项目

国家自然科学基金项目(12402060) (12402060)

国家重点基础研究发展计划(2020-JCJQ-ZD-232-00) (2020-JCJQ-ZD-232-00)

西南交通大学学报

0258-2724

访问量0
|
下载量0
段落导航相关论文