计量学报2026,Vol.47Issue(8):1171-1176,6.DOI:10.3969/j.issn.1000-1158.2026.08.10
压电振动传感器原位自校准方法研究
Research on In-situ Self-calibration Method for Piezoelectric Vibration Sensors
摘要
Abstract
To address problems in environments like wind tunnels,which require long-term online monitoring,periodic disassembly for calibration is difficult to achieve,and traditional vibration sensors with built-in calibration coils are limited to low-frequency self-calibration below 10 Hz,a novel in-situ self-calibration method based on piezoelectric vibration sensors is proposed.This method uses a drive-sensor series integrated structure to enhance sensitivity,applying the driving force generated by a piezoelectric stack actuator under known excitation to the piezoelectric sensor for detection,thereby achieving in-situ self-calibration.The theoretical model's validity is first validated through finite element simulation.Experimental measurements are then conducted for low-frequency and mid-frequency self-calibration.Experimental results demonstrate that,across varying excitation voltages,the deviation between the experimental value and the theoretical value of the sensor charge sensitivity does not exceed 3.58%.Within the 5~300 Hz frequency range,deviations consistently remained below 5%.While accurately achieving mid-frequency self-calibration,sensitivity is significantly enhanced to over 50 pC/(m·s-2),thereby broadening the application scope of in-situ self-calibration.关键词
振动计量/压电振动传感器/自校准/原位校准/电激励Key words
vibration metrology/piezoelectric vibration sensor/self-calibration/in-situ calibration/electrical excitation分类
通用工业技术引用本文复制引用
厉阳,王宇杰,钱胜,宋雷鹏,费正顺,郑永平,张祯毅,项新建..压电振动传感器原位自校准方法研究[J].计量学报,2026,47(8):1171-1176,6.基金项目
国家自然科学基金青年科学基金项目(62303419) (62303419)
浙江省自然科学基金(LO24F030024) (LO24F030024)
浙江省自然科学基金(LQN26F030041) (LQN26F030041)