| 注册
首页|期刊导航|重型机械|薄板坯连铸机漏斗型结晶器型腔解析模型及参数分析

薄板坯连铸机漏斗型结晶器型腔解析模型及参数分析

李武红 曾晶 姚成功 王文学 王永洪 张西锋

重型机械Issue(5):15-22,8.
✕
重型机械Issue(5):15-22,8.

薄板坯连铸机漏斗型结晶器型腔解析模型及参数分析

Analytical model and parameter analysis of the cavity of a funnel-shaped mould for thin slab continuous casting

李武红 1曾晶 1姚成功 1王文学 1王永洪 1张西锋1

作者信息

  • 1. 中国重型机械研究院股份公司,陕西 西安 710018
  • 折叠

摘要

Abstract

The funnel-shaped mould is a key component of high-speed thin slab continuous casting equipment,and its cavity surface morphology directly affects the solidification behavior of molten steel and the quality of the cast slab.To address the difficulty of quantitatively characterizing the continuous variation of cavity parameters along the casting direction using conventional empirical design methods,this study establishes an analytical model for the funnel-shaped mould cavity.Based on the geometric condition that the arc is tangent to the straight section at the meniscus,a power function-based curvature decay law is introduced,and continuous expressions for characteristic parameters including the connecting arc radius,funnel convexity,funnel curve length,and local inherent taper along the casting direction are derived.Numerical calculations are performed using typical engineering geometric parameters,yielding the contour distribution of the funnel zone,three-dimensional cavity surfaces,and the variation curves of the characteristic parameters.A sixth-order polynomial is used to fit the theoretical convexity curve,with a fitting deviation of less than 0.02 mm,meeting engineering design accuracy requirements.The parameter analysis reveals that meniscus convexity H is the dominant control parameter for mould top convexity T0(sensitivity coefficient0.85),while funnel total width L and funnel depth HD are the primary control parameters for local taper G(0)(sensitivity coefficients 0.98 and-0.92,respectively).This analytical model enables quantitative determination of funnel cavity parameters along the entire height of the mould,providing a theoretical basis and data support for structural design,cavity parameter optimization,and copper plate surface machining of funnel-shaped moulds for high-speed thin slab continuous casting.

关键词

薄板坯/漏斗型结晶器/型腔/解析模型/参数分析

Key words

thin slab/funnel-shaped mould/cavity/analytical model/parameter analysis

分类

矿业与冶金

引用本文复制引用

李武红,曾晶,姚成功,王文学,王永洪,张西锋..薄板坯连铸机漏斗型结晶器型腔解析模型及参数分析[J].重型机械,2026,(5):15-22,8.

重型机械

1001-196X

访问量0
|
下载量0
段落导航相关论文