轻工学报2026，Vol.41Issue(4)：66-74,9.DOI:10.12187/2026.04.006
通风孔数对加热卷烟气溶胶逐口粒径及化学组分释放影响
Effects of the number of ventilation holes on the puff-by-puff particle size and chemical component release of heated tobacco product aerosol
摘要
Abstract
[Objective]To clarify the effect of the number of ventilation holes on the physical parameters and chemical component release of puff-by-puff aerosol from heated tobacco products(HTPs).[Methods]Circumferentially heated cigarettes were used as the test samples.The ventilation rate was varied by adjusting the number of ventilation holes,with three conditions of 30,40,and 50 holes.A scanning mobility particle sizer(SMPS)and gas chromatography-mass spectrometry(GC-MS)were employed to determine the puff-by-puff aerosol particle size distribution,D50,number concentration,and the contents of volatile organic compounds(VOCs),glycerol,and nicotine.[Results]Under different numbers of ventilation holes,all puff-by-puff aerosol particle size distributions exhibited a bimodal pattern.As the hole number increased,the particle size peak,D50,and aerosol number concentration all showed a trend of first decreasing and then increasing.The highest total aerosol number concentration was observed at 50 holes,while the puff-by-puff release stability was better at 40 holes.The puff-by-puff variation in VOC components was weakly correlated with aerosol number concentration,and the relative content of organic components decreased as the hole number increased.The nicotine content was positively correlated with the aerosol number concentration to some extent,whereas the glycerol content showed a weaker correlation with number concentration but exhibited an overall trend of first increasing and then decreasing with increasing hole number.[Conclusion]The number of ventilation holes significantly influences the puff-by-puff particle size distribution,number concentration,and chemical component release of HTP aerosols,and a nonlinear relationship exists between hole number and these aerosol release characteristics.关键词
通风孔数/加热卷烟/气溶胶/粒径/化学组分Key words
ventilation hole/heated tobacco product/aerosol/particle size/chemical composition分类
轻工纺织引用本文复制引用
胡安福,金一骁,孙通,夏骏,许汇锋,陈玲红,王凯歌,蒋健..通风孔数对加热卷烟气溶胶逐口粒径及化学组分释放影响[J].轻工学报,2026,41(4):66-74,9.基金项目
国家重点研发计划项目(2023YFE0111600) （2023YFE0111600）
浙江中烟科技项目(ZJZY2023C004) （ZJZY2023C004）
