| 注册
首页|期刊导航|电子与封装|功率器件封装中电沉积铜阵列形貌与应用的研究

功率器件封装中电沉积铜阵列形貌与应用的研究

张艺豪 张景辉 王奉祎 江贤达 陈宏涛

电子与封装2026,Vol.26Issue(9):41-47,7.
✕
电子与封装2026,Vol.26Issue(9):41-47,7.DOI:10.16257/j.cnki.1681-1070.2026.0140

功率器件封装中电沉积铜阵列形貌与应用的研究

Morphology and Application of Electrodeposited Copper Arrays in Power Device Packaging

张艺豪 1张景辉 1王奉祎 1江贤达 1陈宏涛1

作者信息

  • 1. 哈尔滨工业大学(深圳)集成电路学院,广东 深圳 518055
  • 折叠

摘要

Abstract

To improve the low-temperature bonding quality at the Cu-Cu direct bonding interface in power device packaging,Cu arrays with different morphologies are prepared using a bicontinuous microemulsion electrodeposition method.The effects of deposition voltage and Cu salt concentration on the array morphology and bonding performance are investigated.It is found that as the deposition voltage or Cu salt concentration increases,the Cu deposition morphology gradually evolves from a continuous thin layer to granular,columnar-agglomerate,and dendritic structures,accompanied by a simultaneous increase in both surface roughness and porosity.The bonding strength is primarily governed by the combined effects of pore connectivity,interfacial continuity,and the degree of structural interlocking.Under hot-press bonding conditions of 260℃,10 MPa,and 15 min,the columnar-agglomerate array exhibits good interfacial continuity and significant crushing-induced interlocking,resulting in the highest strength;the granular array is prone to forming interconnected unbonded zones,and consequently exhibits the lowest strength among the three Cu arrays;the dendritic array,constrained by high porosity and localized low-density zones,exhibits moderate strength.

关键词

铜阵列/电沉积/Cu-Cu直接键合/剪切强度

Key words

Cu array/electrodeposition/Cu-Cu direct bonding/shear strength

分类

信息技术与安全科学

引用本文复制引用

张艺豪,张景辉,王奉祎,江贤达,陈宏涛..功率器件封装中电沉积铜阵列形貌与应用的研究[J].电子与封装,2026,26(9):41-47,7.

电子与封装

1681-1070

访问量0
|
下载量0
段落导航相关论文